*Amp Suggestions
*Amp Reviews
*Amp Problems

Ask here. PLEASE don't create a thread for 1 question, we already have too much trash in this section.

TIS audio T1802A

http://cgi.ebay.com/TIS-1800-Watt-2-Channe...id=p3286.c0.m14

is it a good brand or should i go with something else

LoL they make rims. I wouldnt buy that except for show.

k thanks im just lookin for a decent amp

no your looking to spend as little as possible and buy the cheapest thing you can...

lol

wow so you're willing to spend $200+ on a new or used amp thats about 2x 600-800 rms @ 2 ohms then to spend less if you can. im asking ?'s first to see if any 1 had experence with it first. either post up a good brand that will meet those specs with a reasonable price thats both 2 ohm stable and 1 ohm stable for later or post up what you would spend on something like it. im not stuck with a certain brand im just not tring to buy something thats overpriced and not worth it

zenon built FTW

What are you looking for e-lo

im trying to get either a 2 ch amp that will do 600-800 rms x2 @ 2 ohms or a 1 ch that can do 1200-1600 rms bridged @ 2 ohms

Got 2 Pair of Phoenix Gold 6.5s. Whats a decent cheap ass amp to buy 4 em? Don't really fuk wit audio like I use to so I don't know who's reputable anymore. It doesn't have to be special by no means, this shits goin in the daily.

you ain't the state champ no more bitch

yes i am

Something that puts out around 100 to 125w per channel would be fine for them. I had a pair being pushed by a MTX 502, got the amp for $80 shipped. Im still using my set now, just replaced the tweeters with some Blaupunkt VC100s I had layin around, but I got a Sundown 125.2 on them now.

Hifonics zxi 1008

1 last ? before i buy the above amp i wanna see if this would work i dont think this will work but im asking anyways

2 15" rated @ 600 w rms svc 4 ohm wired in parallel to get a 2 ohm load bridge them on a hifonics BXI 2010D i belive it will clip but im like 95% sure just making sure

So is it safe to say hifonics is the best bang for the buck?

I mean are they worth using for Long term setups??? or is better to just go with something more high end and more $$$???

Speaking about all amp classes they offer

Hifonics are def not bad amps by any means. Yes, their are better brands out their, but as you mention for bang for your buck, they do well. Just got to remember they tend to be overrated depending on the model, so chances are, your going to get a little less power than you believe. Other than that, they straight.

Hifonics is good to go!

Elo just find a amp that will give you 1200w rms @ 2 ohms.

I got a question for yall, I got a old school Kicker KX 1200.1 (2002 Model I believe) running a single DC Sounds Level 4 18" and it sounds good. I want to sell the single 18" and do (2) 15s, same model subs.

Im thinking about trying to find another KX 1200.1 like the one I have and strap the two amps together, or should I just sell my amp and look for a new amp all together? Subs are DVC2 so I need either 2ohm or .5 for a final load.

Im leaning towards either a Kicker KX2500.1 or a Sundown 2000d at 0.5ohms, just didnt want to spend the money on a brand new amp since I got my 1200.1 for the low. Opinions?

aight thanks i already got the amp of my choice you will find out what it is when it gets here all im saying its none of the amps thats been listedand all i had to pay was $65 shipped + some trades totaling to $200 its a 1500d everyone should know what it is if i say it starts with sun and it was a if you dont get it kill your self price

i've got a kx1200.1 but i need like $300 shipped for it cus its tied up in a deal...but you can find one cheaper. i wouldn't run at .5 ohm if u didn't have to, but it'll be ok with a good electrical setup.

If you relaly want your amp then try to find another Kicker 1500 or go AQ2200

fuck all yall pussies

Man you aint got no vids of the vic setup ?

nope.......... i was gone use my homeboy camera, but once i finally got everything together that trunk lid shit happened so i didn't bother with it

O yea i forgot about that. how did ya do ya doors.

Ass, get a vid of those highs in there, I know Fried got a camera

I guess ill try to get a vid of my DC this weekend if im free.

I apperciate the offer homie, I can get it cheaper but thats not too bad. When I mention about running at 0.5 ohms, I was talking about the Sundown 2000d, if I got a Kicker 2500.1, I could run it at 2 ohms and be fine, or get another KX 1200.1 and strap them together at 2 ohm.

man i'm down here in orlando brah

Shit, I forgot you had moved homie, that was my fault.

No excuse nigga, get a camera, get a vid

i got a camera that records in 720

I just wanna see.

Which amp is better a crunch 1800.4 or a us amps 1600.4

I like my crunch 1400.4

never used US Amps.

So... I say the crunch

I have the crunch 1400.4 right now, but I want to upgrade

well do it.

so get the crunch 1800.4

How are those crunch amps? I know the GP3000d's are a hit or miss with the MOSFETs blowin :/

ur the only person i have heard complain about them................ everybody else i know that have used them loved them

I'm not complaining about them. I'm just saying what I'v heard from others who have run them. Maxxonics may have fixed the problem, Id unno. All I know is the earlier versions of the amps had a problem with the MOSFETs burning due to cheap parts.

I've used 2 Audiopipe AP30001D's and I love them. I've posted pics of the internals on them, too. Beefy to say the least...

Never had any problem with either of them, and they do rated power

yeah i know they do rated power, just two 1500 boards in one amp, crunch gp3000d does it's rated power also

......uh yea

Which Rockford Fosgate amp should i use to push 2 P3s? I know they not the most powerful things out but im just lookign to maintain the consistence.............got all RF mids/highs

http://onlinecarstereo.com/CarAudio/Produc...ProductID=19335

It's 1000x1 @ 1ohm not 1000x2

So it cant be bridged, correct?

NO its a 1 channel (mono) amp.

It was written wrong by the site.

what do yall think of those crossfire vr4000 amps..... i have seen different opinions on them, some say overrated some say underrated, have any of you ever heard one in person, i kinda like the 12.5 voltage rating myself but i'm not positive on how true it is with so many different views for and against them