any one of yall audio heads can instruct me on how to set my amp gains an all that shit...i had unhooked my music for a while...an when i put it back in it dont sound shit like it did b4...an when i took it out my lil nephew fucked round an was turnin the screws on my amp while i wasnt payin attention..

i know bout tha gain knob but idk shit bout the subsonic filter an that low something knob...im lost as fuck...

i have a quantim mono 1500 watt amp(http://cgi.ebay.com/NEW-Quantum-Audio-1500-Watt-Mono-Block-Car-Audio-Amp_W0QQitemZ270401853521QQcmdZViewItemQQptZCar_Amplifiers?hash=item3ef534d851&_trksid=p3286.c0.m14&_trkparms=65%3A12%7C66%3A2%7C39%3A1%7C72%3A1234%7C293%3A1%7C294%3A50)


.jus somethin to move the subs a lil not tryna compete..

an how tha fuck could i wire my subs to get full power from them amp i got 4 kicker cvr 12's tha 2 ohm 1's

Let me see if I can translate, lol.

For starters, ebay link fail should have been this, http://cgi.ebay.com/NEW-Quantum-Audio-1500...%3A1%7C294%3A50

Ok, for you amp, set the gain all the way down. If the sub sonic filter is adjustable, set it low, around 10 to 20hz. The low pass filter, set it around 100hz. This should give you a good start for your settings, you can drop or raise the low filter as needed, but unless your 12s are ported, I think what I recommended for the subsonic should be fine.

And im lost on the 12s, are you saying they are DVC 2ohm? Is that amp 1 ohm stable? If they are and it is, just wire each of them in series, then all of them together in parallel to 1ohm. Hope that helps, but need more info homie.

yea the box is portef bruh...so how i tune all that shit?

well first off what is the box tuned to

disconnect your speakers/subs, connect a dmm to the amps out outs. Set it to AC. Set your HU to 3/4 volume. Play a 60 hz tone. adjust your gain until the dmm reads 31.6 volts. Now hook your speakers up, and your good to go